Goldring G 1022 / Gyger I Nadel


Sehr gutes MM Tonabnehmersystem, verfügt über einen Gyger I Nadelschliff anstelle der aktuellen GX Version mit Vital PH Nadel. Der Unterschied dürfte gering sein...beides sind Fine Line Contact Schliffe. Die GX Nadel war eher dem Umstand geschuldet, daß Goldring nicht mehr mit Gyger Nadeln beliefert meine Info. Guter Zustand. 6 Monate Garantie. Aktueller Listenpreis ca. 420-450€ / SEK 5.100:-


Frequency Response

20Hz - 20kHz ±3 dB

Channel Balance

within 2 dB @ 1 kHz

Channel Separation

better than 25 dB @ 1 kHz


6.5 mV ±1.5dB, 1kHz @ 5 cm/sec

Static Compliance

24 mm/N (lat); 16 mm/N (vert)

Equivalent tip mass

0.45 mg

Vertical Tracking Angle


Stylus Radius

Gyger I

Stylus Type


Load Resistance

47 kΩ

Load Capacitance

150 - 200 pF

Internal Inductance

570 mH

Internal Resistance

660 Ω

Cartridge Mass

6.3 g

Cartridge Mass (inc. fixings)

7.6 g

Low Mass Pocan® Body


The 1000 series uses a strong one piece body which holds the fixed parts securely in place. Made from a special type of ultra-rigid, glass reinforced polyester called Pocan, the body can be tightly bolted to the head shell for maximum efficiency and optimum sound quality. The user replaceable stylus carrier slots tightly into the body with a locating pin preventing unwanted vibrations which would otherwise colour the sound. An integral mu-metal can keeps the generator parts shielded from hum-inducing stray magnetic fields. Because Pocan has a high strength-to-mass ratio, the overall mass of the G1000 series cartridges is kept below 6.5 g. Low mass and moderate compliance keep the natural arm/cartridge resonance within safe limits for easy matching to a wide range of tonearms.

High Efficiency Magnetic Circuit


Finely etched mu-metal is laminated to form the pole pieces around which are fitted two formerless coils of four thousand turns each. This unique design reduces mass and also makes for a very efficient magnetic circuit producing a higher than average output. This construction also reduces the loss at high frequencies inherent in conventional designs, making for a smooth and extended frequency response.

Reduced Moving Mass


The 1000 series uses a unique ultra-low-mass, micro-miniature Alnico V magnet made to a tolerance that can be achieved by no other manufacturer worldwide. Welded to the magnet is a gold plated nickel tie-bar which provides an earth path for vinyl static charge build up and stabilses the cantilever in unwanted vibrational modes. The whole ultra-low-mass assembly is then mounted in a special butyl rubber polymer with optimised damping characteristics.



Preis: 169

Goldring G 1022 / Gyger I Nadel jetzt anfragen